Rounded Rectangle: Information
Rounded Rectangle: Rounded Rectangle: How it is used

BoardworX prototyping boards are very easy to use. They have a fine grid of precisely spaced pads that components are soldered to using a conventional soldering iron.

How is BoardworX used?

These are the basic steps to using the BoardworX SMT prototyping system:

 

1.  Design the schematic for your circuit.

3.  Wire the pin to pin circuit connections as required using fine gauge wire.

2.  Translate the schematic into physical part locations and Place parts on the board in desired locations by placing and soldering pins to grid pads.

4.  Connect, test and use.

BoardworX  follows a very simple procedure to develop prototype boards.

Rounded Rectangle: Rounded Rectangle: Home
Rounded Rectangle: Contact
Rounded Rectangle: About
Rounded Rectangle: Products

BoardworX

How is it used?

Back to top